Installation Instructions
CE-84T-09
The
CE-84T-09 is designed to replace the stock charging system on 2009/2010 FLH-FLT
Twin Cam models without a low mount oil cooler.
These are generalized instructions and are not
intended to be all-inclusive. For more detail see a service manual on your
model.
Alternator Removal
1) Disconnect negative
battery terminal.
2) Drain primary case oil.
3) Remove outer primary
cover.
4) Consult appropriate
service manual and remove compensator sprocket clutch and inner primary case.
5) Remove the
rotor.
6) Remove the 4 stator-mounting screws.
From the out side of the case, push the protruding lip of
the stator wire grommet into the engine case using a small flat blade screw
diver. Pull the wires through the case while removing the stator.
Alternator Installation
Stator Installation
1) Feed the stator wire
through the case. Aligned the posts on the base of the sealing grommet to be
parallel with the case. Pull the grommet through the case until the first lip
protrudes.
2) Mount the stator to the
engine case with the new mounting screws supplied. The screws have
thread-locking compound already applied. Torque the screws to 50-70 in-lbs.
! CAUTION!
When installing the rotor, keep fingers away from the
edge. The magnetic force may cause the rotor to suddenly be drawn inward and
could pinch fingers if in the way.
4) Install the rotor slowly.
Take care not to let the magnets hit the stator. Do not let the rotor snap in
to place or magnet damage may occur.
Note: no shims are used
under the rotor on Twin Cam models.
5) Install shims removed in
step 6 of removal.
6) Install inner primary
case, compensator sprocket and clutch.
7) Install outer primary and
other parts removed.
8) Add oil to primary case.
Remove Old Regulator
1) Remove the two-¼ 20 nuts
that hold the regulator on.
2) Remove the wire clamps and
save for reassembly.
3) Lift the regulator off the
mounting studs and tilt it forward to access the wire connections.
3) Remove the locking clips
and disconnect the stator and battery plugs.
Installation Instructions
CE-607
The CE-607 regulator is designed for use on 2009-2011 FLH-FLT without low mount oil cooler.
Remove Old Regulator
1) Remove the two-¼ 20 nuts
that hold the regulator on.
2) Lift the regulator off the
mounting studs and tilt it forward to access the wire connections.
3) Remove the locking clips
and disconnect the stator and battery plugs.
Install New Regulator
.
1) Remove the retaining clips
from the stator and battery connectors on the new regulator. Save them for
reassembly.
3) Connect the stator and
battery plugs.
4) Install one plug-retaining
clip on each plug.
2) Place the regulator on the
mounting studs. Reuse the stock ¼’ nuts
to fasten the regulator to the frame.
5) Check the routing of all
wires to be sure they are not in a vulnerable position. Keep the wires away
from the motor mount. It moves with the motor and may wear through the
insulation. Be sure the wires are not in the very bottom of lower frame or they
will get pinched if you bottom out.
6) Start the motor and check
battery voltage. Battery voltage should run 14.4 to 14.6 volts.
Have A Good Ride!!
For complete product listing
and technical information see our web site.
Rev.5-10